How Do I Lay Parquet Flooring Adhesive ?

Hello and welcome to another Woodfloor-Renovations Blog Post.

Today I'll talk a little about a rather sticky subject [excuse the pun] which most people attempting to use professional Parquet Flooring Adhesives for the first time may be in for a bit of a shock.

The question today is "How do I lay parquet flooring adhesive ??"

For the first time amateur DIYer its just not as easy as you think, just about all good quality parquet flooring adhesives are incredibly sticky and have an annoying habit of going everywhere.

ALWAYS use vinyl/plastic gloves because if you don't the glue takes some removing from your hands.

The adhesives we use regularly are Lecol 5500, Laybond L16 and Sika 5500s.

These are all excellent products and all basically do the same thing, which in this case is to properly stick Wooden Parquet Blocks to a subfloor.

We did a comprehensive article on this very subject a few months ago which goes into detail about the products, methods and the tools needed to get the best result possible for your project. Have a look at our Parquet Flooring Repair Tips and Hints page.

Hope this helps, Thanks for reading and enjoy the article.

Lacquer Sheen Level....Can I Change Between Coats?

Hello and Welcome to another WFR Blog Post.


Today's question isn't something that I get asked too often, but its a fairly straightforward answer so we'll go with the flow.

The question is "Can I Change the Sheen level of the Lacquer Between Coats ?"

Short answer is YES, but there are of course some proviso's.....In this instance our DIYer has applied 2 coats of Junckers Strong Gloss lacquer onto his Maple Strip flooring and has decided its too shiny.

What I have recommended he do is as follows.....The floor surface in the room will need to be 'Cut Back' which in layman's terms is a light abrading of the lacquer surface, with say a 120 or 150 grit level sanding screen or abrasive, this 'Keys' the surface of the lacquer in readiness to accept the following coats of seal. Then obviously vacuum the surface thoroughly and then tack cloth to remove any fine particles of dust and debris.


You are now ready to apply the next coat of lacquer, in our friends case he was going to use Junckers Strong Matt finish, You really must use products from the same manufacturer when you are applying a different sheen level, they are basically the same products with different levels of matting agents in them, so the chances of the intercoat adhesion failing is remote if the correct procedures are carried out.

Its also not a bad idea to use a new roller to apply the next coat of seal, either that or make sure that the roller or applicator you used to apply the previous coats has been properly washed out.

Hope that helps....Thanks for Reading.